Pressure / Temperature Sensors PT

Detailbild


Pressure/ Temperature Sensor PPC-04/12-PT

▪ Analogue version
▪ 5-pin connection
▪ Can be used with all analogue Hydraulic Testers of the PPC series
▪ Input voltage: 7 ... 12 V DC
▪ Output signal: 0 ... 3 V DC

CAN Pressure / Temperature Sensor PPC-CAN-PT

▪ CAN version
▪ Indication of the sensor status via LED
▪ 5-pin SPEEDCON connection plug
▪ CANopen protocol profile DS406 v3.2 with manufacturer-specific additions
▪ LSS service DS305 v2.0

Left column (copy 2)

Technical Data

▪ Sturdy Stainless Steel housing (1.4301)
▪ FPM (Viton®) gasket
▪ Weight: 200 g / .44 lbs
▪ Suitable for gases and liquids (in the case of aggressive 
  media, only after consultation)
▪ Accuracy (±0,25% FS* typ.)
▪ Automatic sensor recognition
▪ Pressure connection G1/2 (without adaptor)
▪ Calibration certificate on request

Ambient Conditions
▪ Media temperature: -25 °C ... +105 °C /-13 °F ... +221 °F
▪ Ambient temperature: -25 °C ... +85 °C / -13 °F ... +185 °F
▪ Storage temperature: -25 °C ... +85 °C / -13 °F ... +185 °F
▪ Compensated range: 0 °C ... +85 °C / +32 °F ... +285 °F
▪ Load cycles (106): 100

Electrical Data
▪ Response time: 1 ms
▪ Vibration loading: acc. to IEC 60068-2-6 (20g)
▪ Shock loading: acc. to IEC 60068-2-27 (50g)

Left column (copy 2)

Connection Adaptors for PPC Sensors

In addition to the Pressure/ Temperature Sensors (analogue and CAN version), different adaptors and adaptor sets are available that not only connect to the STAUFF Test 20 (SDA20-G1/4-C6F), but also to the Test Couplings of the STAUFF Test 15/12/10 series (SAD20/15-P-C6F, SAD20/12-P-C6F, SAD20/10-P-C6F).

Accessories

Pressure/ Temperature Sensor (analogue):
  A PPC-04/12-CAB3 (3 m / 9.84 ft) Connection Cable is
  needed to connect the sensor to the current Hydraulic
  Testers.
  A PPC-04/12-CAB5-EXT (5 m / 16.40 ft) Extension Cable
  is also available as an option.
▪ CAN Pressure/ Temperature Sensor:
  Connecting the CAN sensor to the CAN Hydraulic Tester
  a CAN Connection Cable and a CAN Terminating Resistor
  is needed.